You can design your own custom glazes, stains, washes, and varnishes with General Finishes intermixable water-based products. See tips and recipes below.

For all of the following mixes, GF recommends the following two steps:

1. Applying a base layer of High Performance Top Coat before applying your custom glaze.
2. Protect all of these finishes with 2-3 coats of top coat when you are finished.

PASTEL GLAZE/WHITEWASH:

Milk Paint + Winter White Glaze Effects OR Milk Paint + Water Based Whitewash Wood Stain

NOTE: Do not add more than 50% paint. If you add more than 50% you will have so much pigment that it will be difficult to wipe away the finish.

CUSTOM GLAZE:

For example, Pitch Black Glaze Effects + Winter White Glaze Effects

Experiment with proportions and colors.

WOOD STAIN AS A GLAZE:

Water Based Wood Stain + 10% High Performance Top Coat
OR
Oil Based Wood Stain + 10% Mineral Spirits

Note: Make sure that you wait 72 hours before applying a water-based topcoat on top of an oil-based stain.

AGED/VARNISH GLAZE:

Water Based Wood Stain  + High Performance Top Coat 50:50 ratio
OR
Dye Stain + High Performance Top Coat 50:50 ratio

CUSTOM STAIN COLORS:

1 part Milk Paint + 1 part Pre-Stain Natural [50:50 mix]
OR
1 part Milk Paint + 1 part Glaze Effects - Clear Base [50:50 mix]
OR
1 part Milk Paint +  2 parts Water Based Stain Natural [1:2 parts]

Note: Proportions are relative to the color you are reducing. Some colors may require 2 parts clear base to reduce strength, others may require 1. Begin with a 50:50 mix, and add more clear base if necessary.

You can further increase the color palette by mixing 2 or 3 Milk Paint colors together before adding the clear base.

There are three ways:

1. Mix with small amount of General Finishes Milk Paint in Snow White.
2. Add a small amount of General Finishes Water Based Wood Stain in White.
3. Professional users could add General Finishes Enduro Pigmented White Poly.

General Finishes stains make beautiful glazes. Just add 10% General Finishes High Performance Topcoat.

Absolutely. All stains and glazes require a sealant. Think of the stain or glaze as the color and the topcoat as protection.

Yes - just add 10% mineral spirits. You can add more mineral spirits, but test first. The mixture will thin out quickly.

Yes - this is not a good place to take shortcuts. GF Gel Stain gets its deep rich hue from a large number of colorants. Seal the stain with a topcoat before applying glaze to prevent "color pull."

The glaze will also glide more easily over the surface after topcoat is applied, allowing you greater control of how much color you want to use. Be sure to wait 72 hours when applying water-based finishes over oil-based finishes.

Here is a sample finish schedule:

1. Prep sand and clean
2. Apply stain
3. Apply a layer of topcoat to prevent color bleed thru and make glazing easier
4. Apply Glaze Effects
5. Apply 2-3 coats of topcoat to protect the entire project